![]() Did an energy audit and figured this would support our needs. So I upgraded to 4 Trojan t-105 wired in series and parallel. The label colors are more subdued than the TM-2025: beige and black. I installed a 2500 watt 12 v aims inverter/charger not realizing 2 cheap rv dealer batteries would get zapped. TM-2025 RV version is a little less wide than the TM-2025A and has surface mounted enclosure. Flush mount or use wiremold box to mount. The positive lead to the TriMetric should be fused with a 1-amp fuse. Allows for a maximum battery bank size of 2500 amp-hours. The 1000A/100mV shunt has the same resistance as the 500A/50mV shunt and may be used interchangeably. ![]() The TriMetric battery monitors are designed to assist in battery care, conservation, and system maintenance of battery powered systems. ![]() Use a 1000-amp 100mV shunt for systems with stacked XW inverters or where continuous current is over 300 amps. Bogart Engineering TriMetric 2030 TM-2030-A > 12/24/48 Volt Battery System Meter with Fuse The recommended fuse holder and 1 Amp fuse are now included. Use the 500-amp shunt if you have a 12V inverter larger than 800 watts or a 24V inverter larger than 1600 watts. Unless it's less than 40 efficient, it wouldn't even challenge one of the Hondas running solo. The converter's output is 55 amps at 14.4v, or under 800 watts. The TriMetric can be located hundreds of feet away from batteries using inexpensive 4-conductor twisted-pair meter wire. It seems that you're suggesting that the PD4655 can utilize all the output of 2 paralleled EU2000i generators, which doesn't make sense. It also records min and max voltage, days since batteries were last charged, days since equalized, and total lifetime amp-hours withdrawn from the batteries. ![]() Another LED flashes when batteries should be recharged, equalized, and during low battery voltage. Amp-hours can be displayed in actual amp-hour numbers or as "% full." An LED lights when the battery is charging and flashes when the battery has been fully charged. It reads volts, amps and amp-hours on an LED display. This updated version of the 2025 amp-hour meter operates on 12, 24 or 48 volts. The Bogart Engineering TriMetric Battery Monitor uses accurate current and voltage measurements to calculate and display the current state of battery charge. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |